|
RB 80
|
|
04-28-2004, 07:24 AM,
|
|||
|
|||
|
Re:RB 80
With the RB80 you can set the amount of gas is added to the loop with each breath, i.e. the inner bellows discharge can be set in relation to the total volume of the outer bellows. Factory setting is 10:1, which is brought down to 8:1 in realtime operation due to some loss clearing the mask, exhaling through the nose upon ascent, etc. Apparently, it is possible to set it so the ratio increases, but it becomes much harder then to notice some of the passive failure modes right away.
|
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RB 80 - by Chuck_Northrup - 04-22-2004, 04:09 PM
Re:RB 80 - by Chuck_Northrup - 04-30-2004, 07:42 PM
Re:RB 80 - by Inspirationdiver - 05-25-2004, 08:26 AM
Re:RB 80 - by Inspirationdiver - 04-23-2004, 08:02 AM
Re:RB 80 - by Dirk Diggler - 04-23-2004, 08:24 AM
Re:RB 80 - by DRE - 04-23-2004, 08:45 AM
Re:RB 80 - by Chuck_Northrup - 04-26-2004, 11:44 PM
Re:RB 80 - by DRE - 04-28-2004, 07:24 AM
Re:RB 80 - by Chuck_Northrup - 04-29-2004, 12:08 PM
Re:RB 80 - by DRE - 04-29-2004, 03:47 PM
|
Users browsing this thread: 1 Guest(s)