ICSD New Shipwreck Challenge...
|
06-03-2012, 08:33 PM,
|
|||
|
|||
Re: ICSD New Shipwreck Challenge...
Yeah the Jeep is getting an apple sized rust hole in one fender, and its a handfull to drive in a crosswind. But hey, at least it smells like an old wet dog insideĀ ;D. About that tackle box and all those mini archeology sites inside it ... I was sitting in front of the garage today soaking up the sun cleaning those jigs one by one and it hit me, I need to find a better way! I came up with a concoction for removing the rust stains from the lures and the tackle box. I squirted CLR kitchen cleaner stuff and shook in a couple teaspoons of "Iron Out". Closed and shook the box with the lures in it, and let is sit for 5 minutes. Pulled the lures out of the box and used a paint brush to scrub the concoction for a minute. Rinsed it out with fresh water and "Ta Daa!" New box and nearly new lures. Now I wanna do it with the other tackle boxes I have been finding. That 4' stainless rod held pretty good, but the whole process almost maxes out the task loading. Holding the line in my left hand to make sure I had enough tension but not so much that I pull the rod from the pivot point. Then I was watching the compass to see when I was heading North again to know when I was at a full circle and needing to let out 5' of line for the next interval (viz was 3' so 5' interval seemed right). Then I would see something just at the edge of my viz and to let out 3', look at the non-object, reel in 3' to get back on the right radius, continue the circle while adding or dumping air to accommodate the side slope... I was busier than a one legged man in a butt kickin' contest.
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread: 8 Guest(s)