Icing chain saws

[Terry]

                          Hey Popo,
                              34 cc is pretty small, not something I'm use to, I mean, I grew up handling a huge tool. The only question is CAN you get a big bar (you can get ANY length of chain) that will fit that small of saw? That was the problem with my McCulloh, 28" was the longest bar I could find for it. I would recommend going above 50cc min.(even used) No doubt this winter part of, "Trinity's, second annual icing challenge" will be a speed challenge on cutting a big block loose, hopefully more then 30" (5' on a side triangle) riding it down (alone), to an open hole. So far, the only competitors (I know of) with an fair sized tool to compete, ( of course, with that huge tool of mine) are Young Joe (Hydro), with his Husky and dangerous Dave Torry (Mcdiver), with his Jonsered, and of course honarable mention to my friend Phil Kerber and his big Stihl. Anyone else with a huge tool, and of course the testero,,,means to drive it, feel free to jump on board.     Trinity